Motor: ME II 3 - 460W, 230V
Immersion depth: 1000 mm (mechanical seal)
Description:
The Pump Set is suitable for low viscosity, flammable and combustible liquids and hydrocarbons. Perfectly suitable for the withdrawal or transfer of explosive media and solvents.
- Optionally available with Ex - plug
- Pump tube equipped with Lutz original hand wheel
- Suitable for Drum emptying alternative fuels, oils, flammable liquids
Features & Advantages
- Optionally with electric or compressed air drive
- No lubricants and therefore no contamination of the pumped medium by lubricants
- Optimized Drum emptying with remaining quantity of approx. 0.1 litres
- No leakage in case of inclined position or repositioning of the pumping unit
- Maximum product utilisation with reduced drum cleaning and disposal costs
- Approved according to ATEX directive 2014/34/EU, category 1/2
Suitable media: | Styrol, Toluol, Nikotin, Butylacetat, Äththylacetat, Aceton, Essigsäure, Ameisensäure |
Pump station material (material): | Niro (Edelstahl) |
Impeller (material): | ETFE (ethylene-tetrafluorethylene copolymer) |
Static seal (material): | FEP ummantelt |
Mechanical seal (material): | Kohle, Keramik, PTFE, HC-4 (2.4610), Edelstahl (1.4571) |
Bearing (material): | Edelkohle |
Drive shaft (material): | Edelstahl (1.4571) |
Delivery rate (up to max. l/min)*: | 77 |
Delivery rate with Nozzle (up to max. l/min)*: | 45 |
Delivery head (up to max. mWS)*: | 14 |
Fluid temperature (max °C): | 100 |
density (up to kg/dm³): | 1.6 |
Operating pressure (max. bar): | lower than 6 bar |
Viscosity (up to mPas): | 500 |
Conveyor wheel shape / drive type: | Radial-flow impeller |
Seal type: | Mechanical seal (MS) |
Immersion length (mm): | from 1000 mm |
Immersion tube diameter (up to mm): | 41 |
Thread (inch) outside: | 1 1/4" |
Schlauchlänge (mm): | 2000 |
Explosion protection: | Yes |
Type of drive: | Electric |
Output (W): | 460 |
Voltage (V): | 230 |
Frequency (Hz): | 50 |
Protection type: | IP54 |
Version: | mit Unterspannungsauslöser |
* Die max. Fördermenge ist ein ermittelter Wert mittels Prüfstand und gemessen mit Wasser bei einer Mediumstemperatur von ca. 20° C. Die Messung erfolgt am Druckstutzen der Pumpe, ohne Schlauch, Zapfpistole oder Durchflussmesser. Die im Einsatz erzielbare Fördermenge ist niedriger und hängt von der individuellen Anwendung, den Medieneigenschaften sowie der Konfiguration der Pumpe ab. Die max. Förderhöhe ist ebenso abhängig von Pumpenausführung, Motor und Medium. Die Viskositätswerte werden mit Öl ermittelt. ** Prüfaufbau: Medium Wasser / Diesel, Durchfluss in Vorzugsrichtung, Beruhigungsstrecke 0,2 m vor und nach dem Durchflusszähler