
with undervoltage release
Explosion-proof universal drive with double-walled housing for pumping flammable and highly inflammable media. Approved according to ATEX Directive 2014/34/EU
- Explosion-proof according to II 2 G Ex db eb IIC T5 or T6
- Two protection classes (I and II) = highest safety standard
- 230V/50Hz, 795 W, protection class IP 54
Explosion-proof according to II 2 G Ex db eb IIC T5 or T6. Double pole on/off switch, splash-proof to IP 54, double pole thermal overcurrent release. 5 m connection cable with safety plug (not explosion-proof), optionally with explosion-proof plug.
These motors cannot be easily disengaged. The explosion-proof ME II universal motors are the patent answer - German patent DE 38 15427 C2 - for pumping many low-viscosity, highly flammable, combustible media.
Here too: Twice as good
The double-walled housing is made of aluminium on the inside and an acid-resistant and non-conductive special plastic on the outside. This prevents corrosive vapours from penetrating into the engine interior. The air flow for engine cooling is conducted between the double-walled housing.
Tested quality and safety
Conforms to the standards EN/IEC 60 079-0, EN/IEC 60 079-1 and EN/IEC 60 079-7, explosion-proof according to II 2 G Ex db eb IIC T5 or T6 and built and approved according to the current explosion protection guidelines Atex 2014/34/EU and IEC Ex.
No fear of tension
All motors of the ME II series have a protective conductor connection. A double insulation is fitted between the live parts and the touchable outer surface of the motor and the pumping station. Especially in hazardous areas, this guarantees protection against discharge sparks when establishing equipotential bonding.
Explosion protection: | Yes |
Type of drive: | Electric |
Output (W): | 795 |
Voltage (V): | 230 |
Frequency (Hz): | 50 |
Protection type: | IP54 |
Version: | mit Unterspannungsauslöser |
Certification: | ATEX Richtlinie (ATEX Richtlinie 2014/34/EU) |
Type: | ME II 7-230 |
* Die max. Fördermenge ist ein ermittelter Wert mittels Prüfstand und gemessen mit Wasser bei einer Mediumstemperatur von ca. 20° C. Die Messung erfolgt am Druckstutzen der Pumpe, ohne Schlauch, Zapfpistole oder Durchflussmesser. Die im Einsatz erzielbare Fördermenge ist niedriger und hängt von der individuellen Anwendung, den Medieneigenschaften sowie der Konfiguration der Pumpe ab. Die max. Förderhöhe ist ebenso abhängig von Pumpenausführung, Motor und Medium. Die Viskositätswerte werden mit Öl ermittelt. ** Prüfaufbau: Medium Wasser / Diesel, Durchfluss in Vorzugsrichtung, Beruhigungsstrecke 0,2 m vor und nach dem Durchflusszähler